Do you want to improve the looks of your Bobber’s backside? Maybe tuck the signals closer to the fender where they belong?

Designed from the ground up, with our own PCBAs.

Our 6061 aluminum, black anodized mini signal housings tuck close to your your fender, but are still bright and visible where you need them to be.

We also include a lighted side marker strip for better visibility.

Can be installed in front and rear positions, but see notes below for adapter kit options needed to do so. Stock license plate light, or our own license plate light tuck are plug and play into the harness too.

No 3D printed parts! No wire splicing or polarity reverse modules! Truly plug and play!

None of these are in our kit:

• electrical tape

• 3D printed parts

• soldering

• wire stripping and splicing

• conversion modules

We designed out mini signals from the ground up, with our own PCBs, to direct plug WITHOUT any sort of conversion module needed. Our lights mimic the function of the OEM stalk lights.

Notes:

1. The mini signals “base kit” option is only compatible with our own taillight tuck kit harness, it does not directly plug into the OEM or other aftermarket harnesses. We offer an adapter kit as a purchase option that allows you to plug the mini signals directly into the OEM harness without our taillight tuck.

2. The mini signal kit does not plug into the OEM FRONT signal harness unless you use the optional front signal harness adapter.

3. We offer red and amber colors. In the US, amber is for the front and red is for the rear, but in other countries they mix it up. Check your local requirements.

4. Do not mix and match our signals with other aftermarket signals. You can use our signals with OEM signals without issue, but if they are used with non-OEM and non-Hemisphere lighting products, the warranty is void and you may have problems with our product, the other product, or both. These lights need to be designed with proper resistance balancing for correct performance, and this imbalance can cause problems if you mix them up.

NOTE: FOR THE FRONT FORK SIGNALS, YOU REUSE YOUR OLD WRAPAROUND BRACKETS. Just unscrew your old signal from it and screw our new one in.

Easy to install in a few minutes, the part that takes the longest is routing the cables.

Features:

• Rugged housing with bright LED PCBAs designed for maximum possible brightness

Installation time: 15-20 minutes

Includes free shipping to the continental US and a free lifetime warranty.

Obviously, this changes the lighting geometry of your bike. Our product has not been reviewed or approved by the DOT, your local highway patrol, your sheriff, your pastor or your mother. Use at your own discretion.